Remote Start; Finishing Installation - Harvia SENTIO Professional B2 Instructions D'installation Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 62
Installation instructions, only for experts
To install the safety shut-off device, perform the following steps:
1. Install the safety shut-off device in accordance with the operating instruc-
tions for the device.
2. Guide the wires for the safety shut-off device through the cable bushing
into the low-voltage connection area
3. Connect the wires to the terminals labelled "OSG" in terminal strip
If a safety shut-off is not installed, a jumper must be fitted at the terminals
labelled "OSG".

5.7. Remote start

This is connected using terminals "S" and "B". "S" stands for sauna mode. "B"
is a +24 V DC output. This must be activated using a switch or an actuator on
terminal "S".

5.8. Finishing installation

1. Connect the earth conductor for the power supply cable and all devices to
the earth rail
g
2. Place the cover of the housing on the upper edge of the junction box.
3. Push the clip locks inwards lightly, and turn the cover of the housing down-
wards until it engages audibly.
.
.
1
p. 17/30
6
.
2
EN

Publicité

Table des Matières
loading

Table des Matières