Device Cleaning - Agu Giraffe Mode D'emploi

Press the START button to turn the light notifica-
tion on or off.
Wait for 4 seconds after selecting the desired mode.
The thermometer will save the parameters and
turn off automatically. The next time you turn on,
the thermometer will work according to the set pa-
rameters.
SWITCHING BETWEEN
THE MEASUREMENT °С AND °F
You should turn off the thermometer to switch be-
tween the measurement modes.
Then press and hold the START button for 8 sec-
onds. The thermometer will enter the measure-
ment units setting mode.
Press the START button to select the desired meas-
urement mode °C or °F.
Wait for 4 seconds after selecting the desired mode.
The thermometer will save the parameters and turn
off automatically. The next time you turn on the ther-
mometer will work according to the set parameters.
10

DEVICE CLEANING

ATTENTION
Do not use chemically active detergents to
clean the device.
1 Clean the device with a piece of dry cloth. If
necessary, the cloth can be slightly moistened.
2 In case of contamination of the infrared ther-
mometer sensor lens, the readings begin to
change immediately as something interferes
with the measurement (usually the read-
ings are too low). To eliminate this problem,
it is enough to wipe the sensor with a soft
lint-free cloth (or cotton swab) moistened
with disinfectant solution. Then it is neces-
42