Installing/Removing Battery Pack; Operation; Trimming Instructions - Black & Decker LHT2220 Mode D'emploi

sufficient power on jobs which were easily done previously. DO NOT
CONTINUE to use under these conditions. Follow the charging
procedure. You may also charge a partially used pack whenever
you desire with no adverse affect on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited
to, steel wool, aluminum foil, or any buildup of metallic particles
should be kept away from charger cavities. Always unplug the
charger from the power supply when there is no battery pack in the
cavity. Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
WARNING:
Shock hazard. Do not allow any liquid to get
inside charger. Never attempt to open the battery pack for any
reason. If the plastic housing of the battery pack breaks or cracks,
return to a service center for recycling.
INSTALLING / REMOVING BATTERY PACK
WARNING:
Make certain the lock-off button is engaged to
prevent switch actuation before removing or installing battery.
TO INSTALL BATTERY PACK:
Insert battery pack into tool until an
audible click is heard (figure 2).
Make sure battery pack is fully
seated and fully latched into
position.
TO REMOVE BATTERY PACK:
Depress the battery release button
in the back of the battery pack and
pull battery pack out of tool
(figure 2).
2
SWITCH
To turn the unit "ON", slide the lock off
button, shown in figure 3, backward and
squeeze the trigger switch. Once the unit is
running, you may release the lock off button.
In order to keep the unit running you must
continue to squeeze the trigger. To turn the
unit "OFF", release the trigger.
WARNING:
Never attempt to lock a
switch in the ON position.

TRIMMING INSTRUCTIONS

1. WORKING POSITION – Maintain
proper footing and balance and do not
overreach. Wear safety goggles, non-
skid footwear when trimming. Hold the
unit firmly in both hands and turn the
unit ON. Always hold the trimmer, as
shown in the illustrations in this manual,
with one hand on the switch handle and
one hand on the bail handle. (figure 4)
Never hold the unit by the blade guard.
8

OPERATION

3
4