Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WORKING
Check for every use:
Or the appliance doesn't show signs of damage.
●
Or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating duet o
●
wind or rain could lead to loose.
Or there are no objects, canvas, sun screens etc. are inside the safety distances.
●
Or the socket you want to use gives the correct tension (230V-50/60Hz) and is
●
grounded.
If everything is all right you can insert the plug into the socket.
The heater has a remote control that works with 2 AAA batteries (not included). While
using, point the remote control to the receiving point of the heater. If there are obstacles
between remote control and the heater, it will not work!
Remove the batteries out of the season, that will extend the life of the remote control.
REMOTE CONTROL
Press the main switch (8) at the side of the device to 'I' (ON). The red indicator light (6)
●
light up (standby-modus).
Subsequently, press the red ON/OFF button on the remote control (X). The red indicator
●
light (6) turns green and the device will operate at half capacity: it hardly diffuses light!
If required, press the full-capacity button (Z). The second green light will also light up;
●
the device will operate at full capacity and diffuses a minimal glow.
To reverse to half capacity, press the half-capacity button (Y). The second green light
●
will turn off and the device will operate at half capacity.
X
Y
Z
By pressing the ON/OFF button again, you switch off the device (standby modus).
●
The device can also be used without the remote control by using the 'manual opera
●
tion' button (7). To that end, press the main switch to 'I'; each time you now press the
'manual operation' button, the device will switch from standby to half capacity to full
capacity to standby to half capacity, etc. The corresponding indicator lights will light up.
You only switch off the device permanently by resetting the main switch on the device
●
to 'O'(OFF).
Warning! When you turn off the unit using only the remote control, the 'standby' remains.
So turn it off using the remote control or the on/off-switch and remove the plug from the
socket!
Allow sufficient time for the device to cool down before you move or maintain it. Pull the
plug out of the wall socket if you do not use the device. When you use the appliance for the
first time (or after a long time again), observe it during the first 10 till 15 minutes to be
sure that is works trouble-free.
CLEANING AND MAINTENANCE
Always disconnect the appliance and let it cool down completely before carrying out
●
any maintenance.
Use a vacuum cleaner to remove dust on inlet and outlet surfaces.
●
Clean the outside of the unit with a damp cloth and then dry it with a dry cloth. Never
●
immerse the unit in water, nor let water drip into the unit.
STORING
Always disconnect the appliance, let it completely cool and clean it before storing.
●
If you do not use the device for a long period, put back the unit and the instruction
●
manual back into the original carton and store in a dry and ventilated place.
Do not place any heavy items on top of carton during storage as this may damage the
●
appliance.
50 | 51
GB
Publicité
Table des Matières
