Ayce LGH-02-2 GOLDEN BEACH Manuel D'utilisation page 25

OPERATION
NOTE!
Since the appliance and its heating elements are slightly greased when
!
delivered, there might be a slight development of smoke and odor when first
time it is used. This is harmless and it will stop after a short while. Be sure to
provide sufficient ventilation during such time.
WARNING!
This heater is not equipped with a device to control the room temperature. Do
not use this heater in rooms when they are occupied by persons not capable of leaving the
room on their own, unless constant supervision is provided.
INSTALLING
Remove all package material and check the appliance, supply cord and the plug for signs
of damage.
Attach the suspension bracket to the device. To that end, put the round parts of the
●
suspension bracket in between the bracket of the device. Screw and tighten
both sides using the large screws, nuts and washers (included in the delivery) through
the large holes (see the illustration).
Pay attention to the mounting place for your heater. The appliance has to be mounted
●
on an incombustible foundation. That foundation has to be vibration free, exact vertical
and stable enough for lastingly holding the appliance free of problems. Check or the
provided (anchor bolts) are suitable, strong enough and qualified for the foundation.
The material provided is identified for a brick wall; for another foundation please ask
the specialist for suitable material.
Check before mounting or the minimum safe mounting distances between heater and
●
environment are strictly followed. The distance between the bottom edge of the
appliance and the floor must be at least 1,8 meter. There must be a distance of at least
0,5 meter between the appliance and the ceiling, roof or other cover. There must be a
distance of at least 1,5 meter at each side between the appliance and walls or the like.
When you install the appliance outside, pay attention that it doesn't catch excessive
wind load.
Attach the heater to the wall. The heater can be attached to the wall in two ways:
A. Semi-permanently by means of the wall support.
B. Permanently by attaching it directly to the wall.
A – Attaching to the wall using the wall support:
Attach the wall support horizontally to the wall using the four cotter bolts included in
●
the delivery.
Hang the terrace radiator in the wall support using the suspension bracket. Slide the
●
suspension bracket as far as possible through the wall bracket so that the small hole
in the suspension bracket winds up under the wall support. Secure the terrace radiator
by turning the wing nut (included in the delivery) as far as possible in the small hole of
the suspension bracket (see the illustration).
B – Directly attaching to the wall:
Attach the suspension bracket horizontally to the wall using the four cotter bolts.
●
Adjust the device to the required radiation angle. The radiator has three positions:
●
straight ahead, downwards under an angle (directed far away) and downwards under
an angle (directed nearby). Secure the device in the required position by screwing the
small screws (X) into the suspension bracket and radiator bracket.
Fasten all screws another time firmly and check or the heater is firmly mounted. Now
●
your infra red heater is ready for use.
For personal protection the installation, to which the heater is connected, has to be
●
equipped with an earth fall device (max. 30 m Amp). Under some circumstances it may
be attractive to make a fast connection between the heater and the main supply, and to
operate the heater with a switch. Because the heater has a high water tightness (IP65)
and for safety reasons, such a connection has to be made by a qualified electrician.
A
X
B
X
48 | 49
GB