Settings & Functions - Dörr SnapShot Mini 12 MP HD Notice D'utilisation

08 | SETTINGS & FUNCTIONS
MODE Press the arrow buttons (10) or to select between PHOTO (image), VIDEO (video recording) or P+V (combined
photo video function). Using the combined photo video function, your camera will take a photo and directly afterwards
a 10 second video sequence.
To save your settings press the OK button (11).
PHOTO SIZE Press the arrow buttons (10) or to select between 4 picture resolutions: 2MP, 5MP, 8MP, 12MP.
To save your settings press the OK button (11).
The highest resolution will not always provide the best result. Picture noise can increase under bad light
conditions.
VIDEO SIZE Press the arrow buttons (10) or to select between 2 video resolutions: 720x480 (VGA) or 1280x720 (HD).
To save your settings press the OK button (11).
PHOTO NO Press the arrow buttons (10) or to select number of photos per release. The camera can take 1 to 9 pictures in
series. To save your settings press the OK button (11).
VIDEO LENGTH Press the arrow buttons (10) or to select length of video recording. Video length can be set from 10 to 60 seconds.
To save your settings press the OK button (11).
PIR INTERVAL Pause of motions sensor – determines the duration during which the motion sensor will not be active after having taken
a record. Can be set from 10 seconds to 60 minutes.
Press the arrow buttons (10) or to select the minutes.
Press the arrow button (10)
To save your settings press the OK button (11).
TIMING SHOT Setting the interval for sequential shots. The interval for sequential shots can be set independently from the motion
detector. Press the arrow button (10)
Timing Delay
O ers the possibility to program the camera in a way to be active within a defi ned period only. Outside of the time
TIMER
frame, there will no motion detection and no pictures will be taken.
Select "O " for this menu item, the camera will be active for 24 hours.
To activate the function press the arrow button (10) to select "On". The next step is to defi ne up to 2 time frames
(timer):
Timer 1 Start
to switch to seconds. Press the arrow buttons (10) or to select the seconds.
Set the time gap between sequential shots in hours, minutes, seconds (e.g. 01:00:00 means one
picture every hour).
Press the arrow buttons (10) or to select the hours.
Press the arrow button (10)
the minutes.
Press the arrow button (10)
the seconds.
To save your settings press the OK button (11).
When timing shot function is activated the LCD Display (8) shows the symbol
Determine start of activity for 1st time frame.
Press the arrow buttons (10) or to select the hours.
Press the arrow button (10)
the minutes.
e.g. 14:30 Timer starts at 14:30 o'clock.
To save your settings press the OK button (11).
to select "On". In the next step, the interval can be determined:
to switch to minutes. Press the arrow buttons (10)
to switch to seconds. Press the arrow buttons (10)
to switch to minutes. Press the arrow buttons (10)
18
or to select
or to select
.
or to select