Installing And Removing The Battery - Canon EOS 6D Mark II Mode D'emploi

Installing and Removing the Battery

Load a fully-charged Battery Pack LP-E6N (or LP-E6) into the camera.
The camera's viewfinder becomes bright when a battery is installed, and
darkens when the battery is removed. If the battery is not installed, the
image in the viewfinder becomes blurred and you cannot perform focusing.
Installing the Battery
You cannot use batteries other than the Battery Pack LP-E6N or LP-E6.
Removing the Battery
36
Open the cover.
1
Slide the lever as shown by the
arrows and open the cover.
Insert the battery.
2
Insert the end with the electrical
contacts.
Insert the battery until it locks in
place.
Close the cover.
3
Press the cover until it snaps shut.
Open the cover and remove the
battery.
Press the battery lock lever as shown
by the arrow and remove the battery.
To prevent short circuiting, be sure to
attach the provided protective cover
(p.34) to the battery.