Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Minimum Gauge for Cord Sets
Volts
Ampere
Rating
120 V 25 (7.6) 50 (15.2) 100 (30.5) 150 (45.7)
240 V 50 (15.2) 100 (30.5) 200 (61.0) 300 (91.4)
More
Not
More
Than
Than
0
6
18
6
10
18
10
12
16
12
16
14
• Do not place any object on top of the charger or place the
charger on a soft surface that might block the ventilation
slots and result in excessive internal heat. Place the charger
in a position away from any heat source. The charger is ventilated
through slots in the top and the bottom of the housing.
• Do not operate the charger with a damaged cord or plug.
• Do not operate the charger if it has received a sharp blow,
been dropped or otherwise damaged in any way. Take it to
an authorized service center.
• Do not disassemble the charger; take it to an authorized
service center when service or repair is required. Incorrect
reassembly may result in a risk of electric shock, electrocution or fire.
• Disconnect the charger from the outlet before attempting
any cleaning. This will reduce the risk of electric shock.
Removing the battery pack will not reduce this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard 120V
household electrical power. Do not attempt to use it on any
other voltage. This does not apply to the vehicular charger.
Total Length of Cord
in Feet (meters)
AWG
16
16
14
16
14
12
16
14
12
12
Not Recommended
Chargers
Be sure to read all safety instructions before using your charger.
Consult the chart at the end of this manual for compatibility of
chargers and battery packs.
Charging a Battery (Fig. 1)
1. Plug
the
charger
into
appropriate outlet before inserting
battery pack.
2. Insert the battery pack (G) into the
charger, making sure the battery
pack is fully seated in the charger.
The red (charging) light will blink
continuously indicating that the
charging process has started.
3. The completion of charge will be
indicated by the red light remaining ON continuously. The battery
pack is fully charged and may be used at this time or left in the
charger. To remove the battery pack from the charger, push the
battery release button on the battery pack.
NOTE: To ensure maximum performance and life of lithiumion
battery packs, charge the battery pack fully before first use.
Charger Operation
Refer to the indicators below for the charge status of the battery pack.
Charge indicators: DCB101
Charging
Fully Charged
Hot/Cold Pack Delay*
Problem Pack or Charger
7
an
FIG. 1
G
Publicité
Table des Matières
