FLAEM Ideal Plus Mode D'emploi page 12

diagram" in point C1. Drugsaver (C1.3) limits the drug from getting dispersed during
treatment and avoids it from getting in your eyes when breathing out.
3. Connect accessories as indicated in the "Connection diagram" on the cover.
4. Sit comfortably holding the nebuliser in your hand, place
the mouthpiece onto your mouth or alternatively use the
nose piece or mask. Should you opt for the mask accessory,
place it on your face as shown in the picture (with or with-
out using the elasticated strap).
5. Start the device by means of switch (A1) and breathe deep-
ly in and out. After inhaling, we recommend holding your
breath for an instant to allow the inhaled drops of aerosol
to deposit. Then exhale slowly.
6. Upon completing application, switch off the device and unplug it.
ATTENTION: If after the therapy session an evident deposit of moisture forms within the
pipe (B), detach the pipe from the nebuliser and dry it with the very ventilation from the
compressor; this operation prevents possible blooms of mould inside the pipe.
SOFTTOUCH FACE MASKS
Soft
biocompatible
material
Dispersion
Limiting Vent
During the inspiratory phase,
the tab, acting as a Dispersion
Limiting Device, bends inwards
towards the mask.
CLEANING SANITISATION DISINFECTION
Switch off the device before any cleaning procedure and unplug the power cable from the
socket.
DEVICE (A) AND TUBING EXTERIOR (B)
Use only a damp cloth with antibacterial soap (non-abrasive and with no solvents of any
sort).
ACCESSORIES
Open the nebuliser by turning the upper part (C1.2) anticlockwise, remove the upper part
(C1.2 and C1.3) as shown in the "Assembly diagram" in point C1.
Then proceed according to the following instructions.
SANITISATION
Before and after each use, sanitise the nebuliser cup and the accessories, choosing one of
the methods described below.
method A: Sanitise accessories C1.1-C1.2-C1.3-C2-C3-C4-C5 under potable hot water
(approximately 40°C) with a gentle, non abrasive dish detergent.
method B: Sanitise accessories C1.1-C1.2-C1.3-C2-C3-C4-C5 in the dishwasher with a
hot cycle.
method C: Sanitise accessories C1.1-C1.2-C1.3-C2-C3-C4-C5 by immersing them in a
solution of 50% water and 50% white vinegar, then rinse thoroughly under potable hot
water (approximately 40°C).
SoftTouch masks have an outer edge made of soft bio-
compatible material that ensures excellent adherence
to the face, and is also equipped with an innovative
Dispersion Limiting Device. These distinctive ele-
ments that distinguish it allow greater sedimentation
of medication in the patient and also limit dispersion.
10
During the expiratory phase, the
tab, acting as a Dispersion Lim-
iting Device, bends outwards
from the mask.