EINHELL DHG 200 Mode D'emploi page 19

Anleitung_DHG_200_SPK7:_
Remedy
1. Refuel the tank
2. Adjust the pump pressure
3. Clean or replace the ignition electrode
4. Clean or replace the fuel filter
5. Clean or replace the fuel nozzle
6. Clean the tank, fill with new fuel
7. Check all electrical connections
8. Connect the ignition cable to the ignition
electrode
9. Replace the ignition electrode
Problem
The fan motor does not switch on. Mains voltage is
provided, the ON/OFF switch is set to ON (I). The
LED is constantly on or flashes.
Possible cause
1. The thermostat is set to a temperature which is
too low.
2. Electrical connection between electronic circuit
board and motor is uninterrupted
Remedy
1. Adjust the thermostat knob to a higher
temperature
2. Check all electrical connections
Problem
The LED flashes.
Possible cause
Thermostat is faulty
Remedy
Replace the thermostat
Problem
Inadequate burning and/or soot
Possible cause
1. Flames are escaping at the front of the housing
2. The heating output is too low
3. Poor fuel quality
4. Generally inadequate maintenance
Remedy
1. Reduce the pump pressure
2. Raise the pump pressure
3. Check whether old or dirty fuel is being used
4. Have the appliance serviced by an expert
Problem
Heater does not switch on and LED does not light up
27.03.2009 14:34 Uhr Seite 19
Possible cause
1. Appliance has overheated and the safety
temperature limiter was triggered as a result
2. No mains voltage
3. Faulty miniature fuse
4. Connection between thermal sensor and
electronic circuit board is interrupted
Remedy
1. Switch the ON/OFF switch to OFF (0) and let the
heater cool down for at least 10 minutes. Then
switch the ON/OFF switch back to ON (I).
2. Check the socket, power cable and extension
lead
3. Check the miniature fuse and if necessary,
replace it.
4. Check all electrical connections
GB
19