Christopeit Sport LB 50+ Notice De Montage Et D'utilisation page 17

USER MANUAL OF COMPUTER 1350
Display:
Speed:
Shows the current running speed in kilometers per hour. (0.8–
10.0km/h or 0,5-6,2mph)
Distance:
Shows the distance in kilometers of running. (0.00 - 99.9Km)
Calories:
Shows the approx. calories in kilocalories. (0.0 - 999 kcal.) (based
on 30kcal per Km)
Meanings of error message codes:
Error code Possible Reason
------- the safety lock is removed
E1 Communication abnormality: abnormal commu-
nication between the controller and the electro-
nic meter after powering on
E2 Explosion-proof protection:
E3 No sensor signal:
E5 Over-current protection:
electronic the communication wire from the electronic
meter has no meter to the controller is not well connected or
display. the transformer is damaged
Note:
Please contact your local dealer if you have checked all the
above listed things but the problem is still there.
Time:
Shows the time of exercising. (0:00 - 99:59Min.)
After reach value of 99:59Min the treadmill stops automatically.
Keys:
Start -key
Press this key to start the treadmill and after a countdown of 3 sec.
the running surface start move.
Stop -key
Press this key to stop the treadmill and the running surface stops
slowly.
„+" –key:
Press this key to increase the speed of treadmill for 0,1km/h.
„-" –key:
Press this key to decrease the speed of treadmill for 0,1km/h.
If you want to switch the computer data from km/h into mph
Please remove the safety clip (48) from computer (46) and press
key "+" and "-" at the same time for 2 seconds.
Solutions
1. Put the safety lock well
2. Change the safety lock switch or magnetic sensors in the computer.
3. If it's still not ok , than change the computer
1. Switch off the treadmill and plug out AC cable
2. Check each section of connection of the communication wires from the electronic
meter to the controller and ensure that all core wires are well connected.
3. Check whether wirings between the electronic meter and the controller are dama-
ged; if yes, replace the damaged wire.
1. Switch off the treadmill and plug out AC cable
2. Check whether the power supply voltage is less than 50% of the normal value.
please ensure correct voltage and test again.
3. Check whether the controller emits the odor of burning; if yes, replace the con-
troller.
4. Check whether motor wires are well connected; re-connect motor wires.
1. Switch off the treadmill and plug out AC cable
2. Check whether the sensor connector is well plugged or whether it is damaged;
plug it well or replace the sensor.
1.Check whether power supply voltage specifications is inconsistent or too low and
use correct voltage specifications for re-test.
2. System self-protection is triggered under excessive current caused by the
excessive load more than the rated value, or some place of the treadmill is jammed
so that the motor can not rotate; thus, the system start up self-protection against
excessive current under excessive load; adjust the treadmill and restart it.
3. Check whether there is over-current sound or burning odor when the motor is
running; replace the motor.
4. Check whether the controller emits abnormal odor; replace it if yes.
1. Switch off the treadmill and plug out AC cable
2. Dismantle the pillar to check connection joints on each section of the wiring from
the electronic meter to the controller.
3. Ensure that each wire core is well connected.
4. or the reason may be the communication power cord defect (damaged or broke
down); in such case, re-connect or replace wires; or replace a transformer.
17