Removing Jammed Staples; Accessories - Makita BST221 Manuel D'instruction

009160
NOTE:
Using the stapler continuously with the head of
•
driven staples remaining above the surface of
material to be fastened may cause damage to the
driver of the stapler and stapler jamming etc..
Checking remaining staples
009161
CAUTION:
Do not operate the tool without staples. It shortens
•
the service life of the tool.
There is a convenient sight window on the right side of
the tool (when viewing the tool from the front). Use this
sight window to check if there are staples in the
magazine. When staples are not visible through the
window, load staples into the magazine.

Removing jammed staples

WARNING:
Always make sure that the trigger are released and
•
the battery cartridge is removed before removing
jammed staples .
Remove the battery cartridge from the stapler.
009162
1. Sight window
1
1. Sub magazine
1
2. Locking lever
2
Press the locking lever on the rear of the sub magazine
and slide the sub magazine backward.
Take out stuck staples that remain inside the opening
that staples are fired from as it appears.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Staples
•
Various type of Makita genuine batteries and
•
chargers
Safety goggles
•
7
or attachments
Only use accessory or
are