Reassembling The Milk Carafe; Monthly Cleaning Of The Milk Carafe; Descaling Procedure - Philips 3100 Série Mode D'emploi

2 Turn the milk dispensing unit upside down and hold it firmly in your hand. Pull the milk tube off the
rubber support (Fig. 32).
3 Press the release buttons on the milk frother and remove the milk frother from the the rubber
support (Fig. 33).
4 Pull the milk frother connector out of the milk frother (Fig. 34).
5 Rinse all components under a lukewarm tap.

Reassembling the milk carafe

1 To reassemble the milk dispensing spout, follow steps 2 to 4 of 'Disassembling the milk dispensing
spout' in reverse order.
2 Place the milk dispensing spout back into the top of the milk carafe.
3 Place the top of the milk carafe back onto the milk carafe.
Note: Before you place the milk froth dispensing spout back into the top of the milk carafe, move the
pin inside the top to the correct position. If this pin is not in the correct position, you cannot place the
milk froth dispensing spout back into the top of the milk carafe (Fig. 35).

Monthly cleaning of the milk carafe

Only use Philips/Saeco milk circuit cleaner for this cleaning cycle.
1 Pour the contents of the milk circuit cleaner sachet in the milk carafe. Then fill the milk carafe with
water up to the MAX indication (Fig. 36).
2 Insert the milk carafe into the machine and place a container under the milk dispensing spout.
3 Press the MENU button, select DRINKS and scroll to MILK FROTH. Press the OK button to start
dispensing the cleaning solution.
4 Repeat step 3 until the milk carafe is empty.
5 When the carafe is empty, remove the container and the milk carafe from the machine.
6 Rinse the milk carafe thoroughly and fill it with fresh water up to the MAX level indication.
7 Insert the milk carafe into the machine.
8 Place the container under the milk dispensing spout.
9 Press the MENU button and select MILK FROTH in the DRINKS menu to start the carafe rinsing
cycle.
10 Repeat step 9 until the milk carafe is empty.
11 Repeat steps 6-10.
12 When the machine stops dispensing water, the cleaning cycle is finished.
13 Disassemble all the components and rinse them under a lukewarm tap.

Descaling procedure

Please use Philips descaler only. Under no circumstances should you use a descaler based on sulfuric
acid, hydrochloric acid, sulfamic or acetic acid (vinegar) as this may damage the water circuit in your
machine and not dissolve the limescale properly. Not using the Philips descaler will void your
warranty. Failure to descale the appliance will also void your warranty. You can buy Philips descaling
solution in the online shop at www.saeco.com/care.
1 When the machine asks you to descale it (Fig. 37), press the OK button to start. To start descaling
without being prompted by the machine, press the MENU button, scroll to select START CALC
CLEAN and press the OK button to confirm.
-
The display reminds you that you have to insert the milk carafe. (Fig. 38) Fill the milk carafe with
water up to the MIN level indication. Insert the milk carafe into the machine and open the milk
dispensing spout.
English
15