Adjusting Coffee Strength; Adjusting Grinder Settings; Handling The Brew Group - Philips 3100 Série Mode D'emploi

1 To adjust the espresso volume, press and hold the ESPRESSO button until the display shows the
MEMO icon (Fig. 17).
-
The machine enters the programming phase and starts to brew the selected drink.
2 Press the OK button when the cup contains the desired amount of espresso.
-
The tick on the display shows that the button is programmed: every time it is pressed, the
machine brews the set espresso volume.
Note: To set the volume of coffee, cappuccino, latte macchiato (EP3363, EP3362, EP3360, EP3559,
EP3551 only), follow the same procedure: press and hold the button of the drink and press the OK
button when the cup contains the desired amount of coffee or milk. Make sure that the milk carafe is
in place and that the milk spout is open.

Adjusting coffee strength

- To change the coffee strength, press the AROMA STRENGTH button.
- Each time you press the AROMA STRENGTH button, the machine selects a higher aroma strength
setting. There are 5 strengths, 1 is very mild and 5 is very strong. After setting 5, setting 1 is selected
again (Fig. 18).
- The display shows the chosen strength. After adjusting the coffee strength, the display shows the
main menu again and saves the chosen aroma strength when you brew a coffee.

Adjusting grinder settings

You can adjust the grinder settings by using the grind setting knob inside the bean container. There
are 5 different grind settings you can choose from. The lower the setting, the stronger the coffee.
Note: You can only adjust the grind settings when the machine is grinding coffee beans. You need to
brew 2 to 3 drinks before you can taste the full difference.
Caution: Do not turn the grind setting knob more than one notch at a time to prevent damage to the
grinder.
1 Place a cup under the coffee dispensing spout.
2 Open the lid of the bean hopper.
3 Press the ESPRESSO button.
4 When the grinder starts grinding, press down the grind setting knob and turn it to the left or right
(Fig. 19).

Handling the brew group

Go to www.philips.com/coffee-care for detailed video instructions on how to remove, insert and
clean the brew group.
Removing the brew group from the machine
1 Switch off the machine by pressing the main switch on the back of the machine.
2 Open the service door (Fig. 20).
3 Press the PUSH button (Fig. 21) and pull at the grip of the brew group to remove it from the
machine (Fig. 22).
4 Remove the coffee residues drawer (Fig. 23).
English
11