Beurer MG 310 Mode D'emploi page 13

• There must be no weight placed on the chair while you are adjusting seat height or back rest.
• Secure the protective covers on the arm rests. Please make sure that you remove these before you fold
the chair together again.
• Connect the power supply with the massager using the connector plug.
• Connect the device to the mains by plugging the plug into the socket.
7. Operation
During first use, place the back rest in the most upright position possible.
Gently press your back against the massage device to start with. Then make sure that you are in a comfort-
able position before gradually shifting your weight onto the massage device.
The massage should feel pleasant and relaxing at all times. Stop the massage or change its position, the posi-
tion of the back rest or the seat height or contact pressure if you find the massage painful or unpleasant.
• Do not force any part of your body, in particular your fingers, between the rotating massage heads and
their mountings in the device.
• Sit comfortably on the massage chair and make sure that you lean against it with your entire back, that
you sit centrally and that the massage heads can move to the left and right of your spine.
• Switch on the massager with the
The device starts automatically with the Shiatsu massage on the full back setting. The LED shows the
current massage region.
You can select other settings as described below:
1. Shiatsu massage
Press the SHIATSU button. Select the desired massage region with FULL BACK (button 2), UPPER BACK
(button 3) and LOWER BACK (button 4).
Spot massage, i.e. Shiatsu massage without vertical movement, can be selected by pressing one of the
two SPOT buttons (number 6). The position of the localised massage can be changed by pressing and
holding one of the two SPOT buttons until the desired position is reached.
Massage intensity
When using the Shiatsu Massage, two different massage speeds are available, which can be selected us-
ing the SPEED button. If you have the rolling massage activated, first press the SHIATSU button in order
to change to Shiatsu Massage and then set the desired massage speed.
2. Rolling massage
Press the ROLLING button. Select the desired massage region with FULL BACK (button 2), UPPER BACK
(button 3) and LOWER BACK (button 4).
When the massage type (Shiatsu or rolling massage) is changed, the preselected region (full, upper, lower
back) is retained. Note that the massage region must be selected again when switching from localised
Shiatsu massage to rolling massage.
heating function
Press the HEAT button (button 5) to switch on the heating function of the massage heads. The blue lights
in the massage heads change colour to red.
• Use the massager for max. 15 minutes and then leave it to cool down. Long massages can lead to over-
stimulation of the muscles, creating tension instead of aiding relaxation.
You can end the massage at any time by pressing the button . Please note that the massage heads must
first return to their start position when the device is switched off. This is indicated by a flashing LED light.
Once the position is reached, the device switches off.
• If the device is stopped be pressing a massage area button twice, it also returns to the starting position
after 15 minutes and then switches off.
button.
13