Ringer; Automatic Answering; Door Latch Activation And Power Schematic - Depaepe Securaccess Compact Pmr Notice D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

SecurAccess Compact PMR – User Guide

A list of 3 numbers stored. Repeated dial selection is 0. In case of busy tone and (or) no answer, the

SecurAccess COMPACT PMR will dial the list of 3 numbers one time and will hang up.

3.8. Ringer

3 levels adjustment: off-low-high and 3 melodies selection. Adjust as shown:

Setting to modify

Ringer level

Ringer melody

3.9. Automatic answering

An auto answer mode can be activated for calling a party standing close to the SecurAccess

COMPACT PMR or to enter the remote programming mode. The SecurAccess COMPACT PMR will

automatically go off-hook after a pre programmed number of rings:

From 1 up to 9 rings when automatic off-hook selection is activated

After 30 rings otherwise.

Setting to modify

Auto answer

3.10. Door latch activation and power schematic

The SecurAccess COMPACT PMR is fitted with a NO/NC driving contact for a remote activation of a

door latch electrical relay.

Following settings can be chosen by local or remote programming:

1. Activation or deactivation of the door latch

2. Activation duration

3. 4 digits access code selection (up to 6 different access codes, Note: 0000 will not work)

4. Fast opening selection

Setting to modify

Door latch activation

Activation duration

access code

Fast opening with « 0# » ou « 0* »

NO: Normally open

NC: Normally close

COM : COMMON

Code

Setting choice

Factory settings are shown in grey

0 3

Low : 0 - High : 1

0 4

0 : ringer off

1 : Melody N°1

2 : Melody N°2

3 : Melody N°3

Code

Setting choice

Factory settings are shown in grey

0 5

Enter the number of rings before auto answer (0 up to 9)

Note: 0 = feature deactivated

3 = factory setting

Code

Setting choice

Factory settings are shown in grey

6 0

0 : activated (factory setting)

1 : deactivated (Door latch not active)

6 1

Enter the number of seconds (from 1 up to 9 seconds).

factory setting = 2 seconds

6 2