Changing The Paper Type; Paper Path Quick Selection - Tally T2240/9 Manuel D'utilisation

Changing the paper type

Changing the
paper type
Paper path quick
selection
Offline Trac.1
Park Load
Single Trac.1
Offline Single
Park
Turn paperlever
Load paper from
Single
Offline Single
Park
14
You can change the paper type (the paper path) either using the paper path quick selection feature
or via the Setup menu.
First cut the fed-out portion of a Continuous Form Feed Paper at the perforated line. To do this,
proceed as follows.
Make sure that the printer is in Offline status; press the
Online
Press the Park
If fanfold paper is in the printer, it is transported to the tear position. "Tear paper
Setup
off" appears on the display. Press any key.
If a single sheet is loaded in the printer, it is ejected.
Select the desired paper path by pressing one of the I keys, in our example Single.
Online
If you do not make a selection within 5 seconds, the printer exits
Setup
the menu.
The printer returns to Offline mode.
Online
The display toggles between...
Setup
and...
Set the Paper Type Selection Lever to Cut Sheet Paper mode (see page 11 Loading
Online
paper).
Setup
The display toggles between...
Online
Setup
and...
Stand the Paper Tray up in the direction indicated by the arrow. While holding
Online
the Paper Tray, pull up the Paper Extension Trays.
Determine the left margin by moving the Left Paper Guide left or right.
Setup
Place a sheet of paper aligned to the Left Paper Guide, and adjust the Right Paper
Guide to the right edge of the paper. Insert the paper between the Left and Right
Paper Guides. The paper is automatically fed to the print start position (see page 11
Loading paper).
key.
Quick start-up
Online key, if necessary.