Tally T2240/9 Manuel D'utilisation page 15

Quick start-up
Paper Holes over
Tractor Pins
Tractor
Fixing lever
With the printing side of the paper facing up, fit the feeding
holes on the left edge of the paper over the Left Tractor pins and
close the Paper Flap.
Fit the feeding holes on the right edge of the paper over the Right
Tractor pins, and close the Paper Flap.
To avoid paper jams, ensure that the same left and
right feeding holes are used, and placed over trac-
tor pins of the same level.
After the paper is set, adjust the left margin by moving the
Tractors left or right. The "[A" mark is the standard print start
position.
Push down the Left Tractor Fixing Lever to lock the Left
Tractor.
Move the Right Tractor to remove any paper slack, and then
push down the Fixing Lever to lock it in place.
If the paper slack cannot be removed by moving the
Right Tractor alone, adjust the position of the Left
Tractor.
Be careful not to stretch the paper so much that it
tears.
Switch on the printer.
The active feeder (Trac.1) is displayed.
Paper is automatically fed when the printer is in Online status
and receives data from the computer.
Press the Load key to load paper before printing.
Loading paper
13