Nilfisk Advance EDS BA 551 Manuel D'utilisation page 90

USER MANUAL
Types of cylindrical brushes available
485 mm-models
909 5823 000 - Polypropylene 0.40
909 5825 000 - Hard nylon 0.60
909 5824 000 - Soft nylon 0.45
Cylindrical brush application guide (suggestions only)
Models
General cleaning:
Concrete
Terrazzo floor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Squeegee installation
1. Install the squeegee (25) and fasten it with the handwheels (26), then connect the vacuum hose (15) to the squeegee.
2. With the handwheel (27), adjust the squeegee so that the rear blade - in all its length - touches the floor and the front blade
is slightly detached from the floor.
Guide to match squeegees and brush/pad-holder decks
Deck model
Deck with one brush (18a), brush diameter: 530 mm
Deck with two brushes (18b), brush diameter: 305 mm
Deck with two cylindrical brushes (18c), brush length: 485 mm
Solution or washing water tank filling
NOTE
If the machine is equipped with EDS - ECO Dosage Solution [switch (77) (optional) enabled] pour clean water
in the tank, otherwise pour solution.
1. Open the filler neck (8).
2. (For machines without EDS - ECO Dosage Solution)
Fill the tank (20) with a solution suitable for the work to be carried out.
Do not fill the solution tank completely, leave a few centimetres from the edge.
Always follow the dilution instructions on the container label on the chemical product used to create the solution.
The solution temperature must not exceed 40°C.
CAUTION!
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.
(For machines with EDS - ECO Dosage Solution)
Fill the tank (20) with clean water.
Do not fill the clean water tank completely, leave a few centimetres from the edge.
The water temperature must not exceed 40°C.
20
Polypropylene 0.40 Hard nylon 0.60
Squeegee model
Aluminium (Fig. 6), width 760 mm
Steel (Fig. 5), width 810 mm
Aluminium (Fig. 6), width 760 mm
Soft nylon 0.45
909 6752 000(2)2006-10 A