Steelcase 1 Série Guide D'utilisation page 4

Steelcase Series 1 Controls
* Optional features (may not
be included in your chair)
CASTERS
The choice of casters depends upon the type of flooring the chair will be used on – for hard floors
(such as stone, wood, laminate, linoleum etc.) select a soft caster. On soft flooring (carpet etc.) select
a hard caster.
WARRANTY
The Steelcase Series 1 chair is tested to 300 lbs and meets ANSI BIFMA requirements. The Steelcase
Warranty applies to multi-shift use. Any servicing of your Steelcase Series 1 chair must be performed
by an authorized Steelcase dealer.
SEAT HEIGHT
To raise the chair, lift your body weight and pull lever up.
To lower the chair, stay seated and pull lever up.
SEAT DEPTH
Pull handle and hold, slide seat forward or back, and release
lever handle to lock. With your back against the chair, you
should have 2"– 3" of space between the back of your
knees and the seat edge. Tip: lift weight out of the seat when
adjusting depth.
BACK TENSION AND BACK ANGLE
Turn the dial to one of the three comfort settings:
• Upright back lock
• Full recline with weight-activated tension + boost
• Full recline with weight-activated tension
ADJUSTABLE LUMBAR*
For additional back support, grasp both handles and slide up
or down. Position the lumbar to fit comfortably into the curve
of your lower back.
HEIGHT / WIDTH / PIVOT / DEPTH ADJUSTABLE ARMS*
Press button under arm caps to adjust height. To adjust arm
cap position, grasp arm caps and slide or pivot in any
direction. Your elbows should stay close to your sides and
your wrists straight.
ADJUSTABLE HEADREST*
Grasp the headrest and move up or down to adjust height.