Preparing The Coffee; Coffee Dispensing - LAVAZZA A MODO MIO Jolie Plus Mode D'emploi

COFFEE DISPENSING

Make sure that the switch-on/supply buttons lights up
to a steady white light.
Never put fingers or objects in the pod-holder.
Only compatible capsules must be introduced in the
pod-holder.
Single-dose capsules are prepared to dispense one
coffee/product. DO NOT use the capsules more than
once. Inserting two or more capsules can cause the
machine to malfunction.
To always have a coffee at the perfect temperature,
it is recommended to preheat the cup with hot water.
Position the cup under the dispensing spout without
inserting the capsule. Press one of the switch-on/sup-
ply buttons to supply hot water enough to pre-heat the
cup.
Place the cup under the coffee dispenser for a classic
espresso.

PREPARING THE COFFEE

23
Remove the drip tray to use cups of different sizes for
a long coffee.
If power supply is interrupted during the coffee supply
cycle, restore power supply and restart the coffee sup-
ply procedure.
If during the supply cycle, water lacks in the tank, water
lack will be indicated by white steady LED on the select-
ed button, while the LED on the other button will start
flashing, then proceed as follows
- Fill the water tank up to the MAX level indicated.
- Press the power-on/supply button previously selected.
The button will start flashing and the coffee supply
procedure will restart.
After 5 supplies the switch-on/supply buttons start
blinking fast with white light to indicate that the
capsules drawer is filled. Empty the capsules drawer
and press one of the buttons to reset the machine.
Now the machine is ready for a new supply.
E N