Replacing The Prime/Spray Valve - Titan IMPACT 1040 Notice D'utilisation

8. Slide the grommet off of the old transducer and onto the new
transducer.
9. Thread the new transducer wire through the mounting plate
and back to the motor controller.
10. Thread the new transducer into the filter housing and tighten
securely with a wrench.
NOTE: make sure the o-ring on the transducer is in place
before threading the transducer into the filter
housing.
11. Push the grommet into the mounting plate.
12. Connect the transducer wire to the motor controller (refer
to the electrical schematic in the Parts List section of this
manual).
13. Place the motor cover back over the motor controller. Secure
with the two (2) motor cover screws.
14. Slide the motor shroud over the motor assembly.
15. Secure the motor shroud with the two (2) motor shroud
screws.
Motor
Cover
Screw
Motor
Cover
Motor
Shroud
Screw
© Titan Tool Inc. All rights reserved.
Motor Shroud
Motor
Controller
Grommit
Tranducer
Filter assembly

replacing the PrImE/SPray Valve

Perform the following procedure using PRIME/SPRAY valve
replacement kit (see Parts List).
1. Push the groove pin out of the valve handle.
2. Remove the valve handle and the cam base.
3. Using a wrench, loosen and remove the valve housing
assembly.
4. Make sure the gasket is in place and thread the new valve
housing assembly into the filter block. Tighten securely with a
wrench.
5. Place the cam base over the valve housing assembly.
Lubricate the cam base with grease and line up the cam with
the filter block using the dowel pin.
6. Line up the hole on the valve stem with the hole in the valve
handle.
7. Insert the groove pin into the valve handle and through the
valve stem to secure the valve handle in position.
Gasket
Valve Housing
Assembly
Dowel Pin
Cam Base
Valve
Handle
NOTE: when using "HOT" solvents, replace Viton o-ring
with optional PTFE o-ring (700-897). Install with
o-ring tool (700-890).
11
Filter
Housing
Valve Stem
Groove Pin
Viton o-ring
English