Controller Controls, Indicators And Connectors - Varian PTB Turbo V 700 HT 969 9445 Notice D'emploi

16 Instructions for Use
Use

Controller Controls, Indicators and Connectors

The following paragraph illustrates the Controller control panel and
interconnection panel. More details are contained in the appendix
"Technical Information".
Figure 2
1 Keyboard push-button for LOW SPEED mode selection. It is active only when the front
panel operation has been selected. Pressed once, the pump runs at about 2/3 of the
nominal speed. To unselect the mode, press the push-button again.
2 Keyboard push-button for START, STOP, RESET mode selection. It is active only when
the front panel operation has been selected. By pressing once the starting phase begins;
if pressed again it stops the pump. If the pump has been stopped automatically by a
fault, this push-button must be pressed once to reset the controller and a second time
to restart the pump.
3 Keyboard push-button to recall on the display the cycle number, cycle time and
pumplife.
4 Keyboard push-button to recall on the display the upper bearing temperature, lower
bearing temperature, pump power and rotational speed. It is always active regardless of
the operating mode selected. Push-buttons 3 and 4, if pressed together for at least 2
seconds put the controller in a routine where it is possible to program some operation
parameters.
5 LCD back-lighted alphanumeric display: dot matrix 2 lines x 16 characters.
230/304
Controller 969-9445, 969-9545 front panel
Turbo-V 700HT Controller User Manual / 87-900-877-01 (F)