K2 Pumps WPS05002K Notice D'utilisation page 35

6. Install the new seal assembly.
a. Insert the silicon carbide seal and the rubber gasket into the recess of the Seal plate.
NOTE: To help facilitate installation, apply a drop of liquid soap to the outside diameter of the rubber gasket. Make
certain that the polished surface of mechanical seal and motor shaft are kept clean and free of dirt and/or oil.
b. Slip the remaining parts of the rotary seal assembly onto the motor shaft.
NOTE: Apply a drop of liquid soap to the inside diameter of the rubber drive ring.
7. Replace the impeller and diffuser removed in Steps 2 & 3.
8. Reassemble the pump body to the motor and mounting bracket.
For Professional Technical Support call 1-844-242-2475
ITEM DESCRIPTION
1
2
3
4 Mechanical Seal Assembled,M301-12
5
6
7
8 Pressure Gauge
9
10 Pressure Tube
11 Mounting Ring
12 Pressure Switch
13
Motor
Seal Plate
O -ring
Impeller
Diffuser
Diffuser Ring
Pump Body
Rear cover
QTY.
1
1
1
1
1
1
1
1
1
1
1
1
1
15