Westfalia 303 140 300 107 Instructions De Montage page 20

GB
Lay the grey/violet and blue/green wire end to the left tail light.
Connect the wire ends with the enclosed terminal connecter to the vehicle's wires at the tail lights
as follows.
Wire color
-9/01, Compact 09/01-
blue/green
grey/violet
Lay the remaining wire lane ends on the right side of the vehicle (along the vehicle's wire lane) to
the fuse strip above the glove compartment.
Release the chamber connector housing from the main fuse covering and remove the main fuse
covering. (see illustration 6 and 7)
Connect the enclosed continuous plus cable to the vehicle's F 107 (50A) fuse. See illustration 7).
Insert the flat plug receptacle of the red single wire and the flat plug receptacle of the enclosed single
wire into the fuse holder, attach the fuse clips, insert the fuse (20A) into the fuse holder and place
the cover onto the fuse holder.
( 13 pin )
Pull the chamber connector with the vehicle's blue/yellow wires (function reverse lights) out of the
chamber connector housing and insert the plug receptacle of the green wire of the wire lane.
(See illustration 6)
Re-plug the chamber connector into its housing; if necessary, connect directly with a cutter
connector.
Open the secondary locking mechanism of the fuse strip and insert the plug receptacle of the
red/blue wire of the wire lane into fuse box 44 and lock it into place. (See illustration 8)
Close the secondary locking mechanism again and insert the enclosed flat plug fuse 20A into fuse
chamber 44.
( all )
Carefully lift up the panel of the light switching center using a flat screwdriver, remove the light
switch center and pull out the connecting plug. (See illustrations 9 and 10)
Lay the remaining ends of the blue/brown-yellow wire from the glove compartment to the
mounting position of the light switching center.
Carefully pull the blue and brown contact holders out of the connecting plug's housing covering
and insert the contact receptacle of the blue/brown-yellow wire of the wire lane into the free
chamber - no. 9 (blue contact holder) and lock it into place. (See illustration 11)
Reassemble the connecting plug in the reverse order and place it on the light switching center.
20
Chamber No. (light plug)
5 6
2 8
Function
Touring
2 Direction indicator, left
4 Left tail light