Redialing - Sony IT-ID20 Mode D'emploi

Additional tasks
To
Adjust the handset volume
Mute your voice
Switch to tone dialing
temporarily

Redialing

1
Pick up the handset (or press (DIAL/ON HOOK)).
"=== TALK ===" appears on the display.
2
Press (REDIAL/PAUSE) to redial the last number dialed.
The last number dialed appears on the display and is
automatically redialed.
Note
If the last number dialed exceeds 32 digits or if it is erased, the number cannot
be redialed.
Tip
When the redialed number exceeds 16 digits, the first 16 digits are displayed,
and then the remaining digits are displayed one by one while the displayed
numbers move from right to left across the display.
To check the last phone number dialed
When not making a call, press (REDIAL/PAUSE).
The number appears on the display for 20 seconds.
To dial the number, pick up the handset (or press (DIAL/ON HOOK))
while the number is displayed.
Note
"NO DATA" will appear on the display if the last dialed number exceeds 32
digits or if it is erased.
To erase the last phone number dialed
While the phone is not in use, press (REDIAL/PAUSE) twice within 20
seconds.
The number will be erased from the memory.
You can also erase the last phone number redialed while displaying
the number. When not making a call, press (REDIAL/PAUSE), confirm
the displayed number and then press (REDIAL/PAUSE).
Do this
Set the HANDSET VOLUME switch to H
(high), M (middle) or L (low).
Press (MUTING) to disable the microphone.
"MUTING" appears on the display.
Press (MUTING) again to cancel.
Press (* TONE) after you're connected.
The line will remain in tone dialing until
disconnected.
17 US
Basics