NiceHome RC200 Instructions Et Avertissements Pour L'installation Et L'utilisation page 33

4 When the time you wish to set has
elapsed, press the key associated with
control of the timer. The relay will be
deactivated (Off) and the measured time
will be memorized
3 long beeps will signal that the time has been programmed successfully;
the following 1 or 2 short beeps indicate whether timer1 or timer2 has been
programmed.
Clearing the Receiver Memory
There may be cases when the RC200 radio receiver memory has to be cleared.
The memory can be cleared using:
– non-memorised transmitters or those which have been memorised for
"Timer" commands starting from point A.
– A previously memorized transmitter, starting from step N. 1
The following items may be erased:
– Transmitters only, proceeding up to step 4
– All the data (transmitters and timers), completing the procedure up to
step 5.
Table [H] Clearing the Memory
With the radio receiver
A
➨
not powered, remove
the jumper from the
board (after clearing the
memory, the jumper must
be reinstalled).
B Power the radio receiver and wait for the
initial beeps
"Relay OFF"
Example
English – 13