NiceHome RC200 Instructions Et Avertissements Pour L'installation Et L'utilisation page 30

Table [E] Memorizing additional transmitters
in Mode 2
1 Press and hold down the desired key on
the new transmitter (New TX) until you
hear a beep (after approx. 5 seconds),
then release the key
2 Within 5 seconds, press and hold down
for approx. 5 seconds a previously
memorized key on a transmitter (old TX)
until you hear 2 short beeps, then release
the key
3 Within 3 seconds, press again the same
key on the previously memorized tran-
smitter (old TX) as many times as the
number corresponding to the desired
command: 1 = On-Off; 2 = Man Present;
3 = Timer1; 4 = Timer2
4 After approx. 3 seconds you will hear a
number of beeps corresponding to the
selected command
5 Within 2 seconds, press and release the
desired key on the new transmitter (new
TX) to confirm the programming
The 3 final beeps signal that the new transmitter has been correctly memorized.
If the memory is full (30 transmitters), 6 beeps will signal that the transmitter
cannot be memorized.
10 – English
Example
New TX
5s
Old TX
5s
Old TX
X1...X4
X1...X4
New TX