NiceHome RC200 Instructions Et Avertissements Pour L'installation Et L'utilisation page 31

Memorizing a new transmitter like a previously memorized transmitter
It is possible to memorize a new transmitter so that it operates exactly like a
previously memorized one. If the old transmitter was memorized in Mode 1,
the new one will also operate in Mode 1 and a single memorization stage will
be required. If the key on the old transmitter was memorized in Mode 2, also
the key on the new transmitter will be memorized in Mode 2 and will perform
the same function. If you wish to memorize more than one key you will have
to perform a memorization procedure for each key.
Table [F] Memorizing a new transmitter
exactly like a previously memorized
transmitter
1 Press the key on the new transmitter
(new TX) to be memorized and hold it
down for at least 3 seconds, then
release it
2 Press the key on the previously
memorized transmitter (old TX) and hold it
down for at least 3 seconds, then
release it
3 Press the key on the new transmitter
(new TX) again and hold it down for at
least 3 seconds, then release it
4 Press the key on the previously
memorized transmitter (old TX) and hold it
down for at least 3 seconds, then
release it
The 3 final beeps signal that the new transmitter has been correctly memorized.
If the memory is full (30 transmitters), 6 beeps will signal that the memory is not
capable of memorizing any additional transmitters.
Example
New TX
3s
Old TX
3s
New TX
3s
Old TX
3s
English – 11