Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To connect the RC200 radio receiver,
the normal power cable to the equip-
ment to be controlled must be "inter-
rupted" (Fig. 1).
WARNING: Electrical systems
must be set up by qualified and
experienced personnel in compli-
ance with current legislation. As
the cable clamps do not provide
protection against pulling and the
removable cable cap can be separated, the RC200 container must be
positioned where it is inaccessible to the general public. Said con-
tainer does not guarantee protection against access to those parts
of the system which are live. If the RC200 radio receiver is installed
outdoors, keep in mind that the cable holders are waterproof only for
round cables with a diameter of 6.5 to 8.5 mm.
01. Make sure there is no voltage anywhere in the electrical circuits.
02. Cut the power cable to the equipment to be controlled.
03. Open the RC200 enclosure and remove the "cable holding cap" (Fig. 2).
04. Strip the sheath off the two ends of the cable approx. 3 cm, then strip
the single conductors approx. 5 mm.
05. Thread the two cables through the holes in the cable holding "cap"
(Fig. 3).
06. Pull the board out a few centimetres (Fig. 4).
07. Connect the conductors to the terminals (Fig. 5).
08. Fold the conductors (Fig. 6).
09. Push the board back inside the enclosure, making sure that the
stripped sections of cable are not exposed, then slide the "cap" along
the cables until the enclosure is closed tight.
10. The RC200 radio receiver does not require mounting, it can be posi-
2 – English
INSTALLATION
— STEP 3 —
1
Publicité
Table des Matières
