Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Example of memorization in Mode 1
Key 1
Key 2
Key 3
Key 4
Even if one or more transmitters have already been memorized in Mode 1, ad-
ditional transmitters can be memorized in Mode 1, as described in Table [B].
Table [B]
Memorizing additional transmitters
in Mode 1
1
Press and hold down one of the keys in
the desired pair (1-2 or 3-4) on the new
transmitter to be memorized (New TX) until
you hear a beep (after approx. 5 seconds),
then release the key
2
Slowly press one of the keys in the
desired pair on a previously memorized
transmitter (old TX)
3
Once again, press and release the key
on the new transmitter you pressed
according to step 1
The 3 final beeps signal that the new transmitter has been correctly memorized.
If the memory is full (30 transmitters), 6 beeps will signal that the memory is not
capable of memorizing any additional transmitters.
On on RC200 no. 1
Off on RC200 no. 1
On on RC200 no. 2
Off on RC200 no. 2
Example
New TX
5s
Old TX
New TX
English – 7
Publicité
Table des Matières
