df models KL-80 Notice D'utilisation page 27

> Or: Press the set button again until you have reached the desired value.
Press the set button twice, the LED will blink twice: drag brake 5%
Press the set button 3 times, the LED button will blink 3 times: drag brake 10%...
Press the set button 4 times, the LED button will blink 4 times: drag brake 20%...
Press the set button 5 times, the LED button will blink 5 times: drag brake 40%...
Press the set button 6 times, the LED button will blink 6 times: drag brake 60%...
Press the set button 7 times, the LED button will blink 7 times: drag brake 80%...
Press the set button 8 times, the LED button will blink 8 times: drag brake 100%...
3. Programing step:
> Start the programming mode.
> Press and hold the set button for 3 more seconds until the green LED has blinked twice.
> The green LED blinks three times.
You are in the third programming step "undervoltage protection".
> To set the third programming step "undervoltage protection", release the set button and
press it again.
The red LED will blink once for the first selection option: undervoltage protection "OFF"
> If you want to quit programming here, switch off the speed controller and and restart it
subsequently.
> Or: Press the set button again until you have reached the desired value.
Press the set button twice, the LED will blink twice: 2.6V/cell
Press the set button 3 times, the LED will blink 3 times: 2.8V/cell
Press the set button 4 times, the LED will blink 4 times: 3.0V/cell
Press the set button 5 times, the LED will blink 5 times: 3.2V/cell
Press the set button 6 times, the LED will blink 6 times: 3.4V/cell
Proceed in the same manner for the additional programming steps.
A signal sound will be heard (in the programming mode) to simplify programming. If an LED
blinks more than 5 times, a long signal sound will be heard and the LED will be lit longer. If the
LED is lit longer followed by a short blinking (a long signal sound followed by a short one), then
that indicates the 6th selection option. Accordingly. a longer shining of the LED followed by two
short blinks (a longer signal sound followed by two short ones) indicates the 7th selection opti-
on.
-  -