Connecting Headphones - Teac NR-7CD Mode D'emploi

L
Skip (.//) buttons
During CD playback
Use to skip to the previous or next track.
Press and hold for at least one second during playback to
search forward/backward (page 22).
During NET and Bluetooth playback
Use to skip to the previous or next track in the playlist.
M
Tray open/close (-) button
Press to open and close the disc tray.
N
VOLUME knob
Use to adjust the volume. Turn right to increase and left to
decrease the volume.
o Volume settings are saved separately for speaker and head-
phone outputs.
O
PHONES jack
Connect headphones (3.5mm stereo mini plug) here.
o This headphone amp circuit uses a four-pole connector with
independent left and right for grounding. Ordinary plugs
with 3 or 4 poles can be used.
o If headphones are connected to this unit, audio will not be
output from the SPEAKER terminals on the rear panel.
NOTE
The following buttons on the unit and the remote control function
with CD, NET and Bluetooth playback.
Stop (8) button
Play/pause (7/9) button
Skip (.//) buttons
o This unit cannot be used to create playlists, for example, on
another unit connected to it. Playlists must be created and
other settings must be made to enable playback on connected
devices.

Connecting headphones

Wiring illustration
L+ R+
V
CAUTION
While wearing headphones, do not connect or dis-
connect them or turn the unit on or off.
Doing so could result in a sudden loud noise that
could harm your hearing.
Always set the volume to minimum (−∞ dB) before
putting headphones on.
L− R−
EN
15