Copying Images To The Computer - FujiFilm instax Square SQ 20 Guide D'installation

Copying Images to the Computer

Connect the camera to the computer and copy images.
~
Start up the computer.
Ÿ
Turn the camera off.
!
Connect the camera to the computer using the
supplied USB cable.
Make sure the orientation is correct and the
connectors are fully inserted.
Connect the camera directly to the computer.
Do not use a USB hub or keyboard.
⁄
Turn the camera on.
Select (still picture) or
to the file type to copy.
@
When the computer recognizes the camera, select
the camera on the menu and start copying the
images.
¤
Disconnect the camera from the computer.
After you have finished copying the images, turn
the camera off, and then disconnect the USB cable
from the computer.
Caution
• Do not cause the battery to run out while copying the
images; otherwise, the images may be damaged.
• Do not turn the camera off or disconnect the USB
cable from the computer; otherwise, the images may
be damaged or lost.
• When you change the memory card, make sure the
camera is disconnected from the computer.
• Do not disconnect the camera from the computer
or unplug the USB cable soon after the "Copying"
message goes off. The camera may access to the
computer for a while even after the message goes off
when you copy a large file.
• You cannot copy an image file from the computer to
the camera.
(movie) according
EN
29