Christopeit Sport RUNNER PRO MAGNETIC Notice De Montage Et D'utilisation page 17

Step7:
Checks
1. Check the correct installation and function of all screwed and plug con-
nections.
2. When everything is in order, familiarise yourself with the machine at a
low resistance setting.
Note:
Please keep the tool set and the instructions in a safe place as these may
be required for repairs or spare parts orders becoming necessary later.
How to move/store your treadmill:
1. Pull the locking Knop (54) and place your hand on the end cap of the
system frame then folding the system frame up and lock it with locking
knob.
2. Place your hands on top of the handrails, than lean the machine toward
your body sideways, this way you can move it easily.
3. Pull out the locking knob (54) and fold down slowly the main frame (1) to
the fl oor and ensure that the locking knob (54) secures this position.
Possible faults and their remedies
Most faults which can occur can be rectifi ed by the following, simple
steps.
1. The computer no longer operates correctly
a) Check that all plugged connections are made correctly.
b) Check whether the batteries still have suffi cient capacity/power.
2. The belt (36) no longer runs evenly
To achieve even running and to reduce the friction between the belt (36)
and the board (35), you should apply a silicone-based lubricant occasio-
nally on the slip surface beneath the belt (36). Ensure that the lubricant is
not based on an oil or petroleum compound.
3. The belt (36) no longer runs centrally or slides
a) If the belt (36) has run to the left of the direction of running, turn the left
screw (5) clockwise and the right screw (5) anticlockwise by a quarter of a
revolution each. Run briefl y on the belt.
If the belt still does not run centrally, repeat the above procedure.
b) If the belt (36) has run to the right of the direction of running, turn the left
screw (5) anticlockwise and the right screw (5) clockwise by a quarter of a
revolution each. Run briefl y on the belt. If the belt still does not run central-
ly, repeat the above procedure.
c) If the belt (36) slips, turn both screws (5) clockwise by a quarter of a re-
volution. Run briefl y on the belt. If the belt (36) still slips, repeat the above
procedure.
Instruction for a mechanical treadmill, slowed
down magnetically.
Settle the treadmill on an even ground and lock it with the safety knob (54)
for the training start.
And also lock it with the safety knob (54) for the fold up position.
The stability of the piece of apparatus is not to be endangered by putting
something under the treadmill like a piece of wood or something similar.
Guarantee before starting the training that treadmill is not loaded higher
than with the maximum permissible weight of body and that there is en-
ough space for security of 2 000 mm x 1 000 mm.
Run in the middle of the running surface, hold yourself tight and don't step
on the slip board (35) or on the foot mats (10). Only run in increasing with
look at the Computer on the treadmill during the running. In emergency
step of the treadmill lateral and hold on to the handle (29).
When nobody is on the treadmill it will stop automatically.
17