Christopeit Sport RUNNER PRO MAGNETIC Notice De Montage Et D'utilisation page 16

Step 4:
Installation if the extension tube (53) at foot (23) and main frame (1).
1. Put the extension tube (53) with bottom part into appropriate holder of
foot (23) and screw it tightly by using screw M8x50 (63), washer (59) and
self locking nut (61).
2. Fold up the main frame (1) vertically and insert the extension tube's top
side into the appropriate holder at main frame (1). Screw it tightly by using
screw M8x40 (66), washer (59) and self locking nut (61).
(Note: The connection points shouldn't tighten too much, so that the ex-
tension tube (53) can move easily during fold up and down the main frame
(1).)
Step 5:
Installation of the handrail (29) on the left (33) and right (24) support
with screws M8x45 (65) and curved washers 8//22 (60).
1. Put one curved washer (60) on each screw (65).
2. Place the hand rail (29) to the upper ends of the supporting pipe (33)
and (24) and bring the above mentioned borings in (29) to rest above the
borings in (33) and (24).
3. Push the screws (65) with washers (60) through the holes and screw in
fi rmly.
Step 6:
Installation of the computer (30) at handrail (29) and drink bottle hol-
der (56) at support (24).
1. Push the ends of the sensor cable (68) (projecting from the support (24))
and sensor wire (31) (from handrail (29)) together
2. Insert the necessary batteries (2xMignon AA 1.5V) in the computer.
3. Place the computer (30) on the computer bracket at the middle of the
handrail (29) and align the holes in the computer with the holes in the bra-
cket.
4. Screw the screws (49) with washers (51) through the holes and tighten
fi rmly.
5. Plug the end of the sensor wire of handrail (31) into the associated so-
cket of the computer (30).
6. Insert the plug of the hand pulse (14) in the likewise corresponding so-
cket of the computer (30).
7. Put the bottle holder (56) at the handlebar support (24); fi x it with two
screws (67) at appropriate position and insert the bottle (55) into the bottle
holder (67).
8. Place the handle cover (27) onto the screw connection of hand rail (29).
16