Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Filter sensor
Whenever a filter is blocked and needs cleaning, the red
LED in the handle will illuminate. Clean dust from filter (See
"Cleaning the Dust Bowl and Filter" section).
Nozzle / Accessories
•
A crevice tool
is built into the nozzle
4
crevice tool as shown in Figure E, until it clicks in place.
•
To shorten the crevice tool, depress the crevice tool
release button
5
as shown in Figure F and slide the
crevice tool into the nozzle.
Figure E
Figure F
Attaching the pet head (Fig. G)
•
Slide the nozzle
3
into the opening of the motorized
pet head
13
, ensuring that the connectors
with the recesses
17
Figure G
13
D
Detaching the pet head (Fig. H)
•
Push the motorized pet head release button
•
Lift the main unit from the pet head
4
. Extend the
3
16
. An audible click will be heard.
3
17
16
14
.
13
Figure H
Removing the beater bar from the pet
head (Fig. I)
•
Press the beater bar release button
•
Lift the beater bar
•
The beater bar can now be freed from any hair and
accumulated debris.
Figure I
Dry pick up
•
For everyday spills of dry material.
•
Do not fill the dust bowl
intake chute.
Optimizing the suction force
In order to keep the suction force optimised, the filters must
be cleared regularly during use.
engage
EMPTYING AND CLEANING THE PRODUCT
Removing the dust bowl and filters -
Figures J & K
WARNING: The filters are reusable and should be
cleaned regularly.
•
Press the dust bowl release button
insert of Figure J, then pull the dust bowl
as shown in Figure J.
Figure J
.
14
18
19
up and out of the pet head.
18
8
beyond the end of the
9
.
19
as shown in the
straight off
8
Publicité
Table des Matières
