Hazet 9032-1 Mode D'emploi page 14

GB USA
Possible faults and their causes
• The tool rotates slowly or does not work
Dirt or abraded particles have gummed up
the motor
Air pressure is too low
Lack of oil, rust deposits
Worn-out ball bearings
Lack of oil
Air pressure is too low
• Tool works automatically
Defective operation trigger
• Tool blows out moisture
Water in the compressed air tank
Note:
The water separator/filter works well only if
the through-flowing air is cold. The water
separator/filter should be installed as far
away from the compressor as possible.
Install an air dryer.
Do not leave plugged-in pneumatic tools unattended.
Always wear personal protective clothing and safety equipment.
14
Trouble Shooting
• The tool rotates slowly or does not work
Let drip oil off through the air inlet,
blow out motor and use special pneumatic
oil, see "Maintenance and Cleaning"
Check compressed air installation, the wor-
king pressure must be 6.2 bar. Check air
compressor and, if necessary, adjust cor-
rectly.
Use special pneumatic oil,
see "Maintenance and Cleaning"
Professional repair necessary
Use special pneumatic oil,
see "Maintenance and Cleaning"
Check compressed air installation, the wor-
king pressure must be 6.2 bar. Check air
compressor and, if necessary, adjust cor-
rectly.
• Tool works automatically
Professional repair is necessary.
• Tool blows out moisture
Drain water from the compressed air tank.
Install filter/water separator.
Technical data are subject to change without notice
Corrective measures