Hazet 9032-1 Mode D'emploi page 11

• Do not use the tool in explosive atmos-
phere. Tools like die grinders can produce
sparks that may ignite combustible materi-
als. Never operate tools in proximity to com-
bustible substances like petrol, naphtha,
detergents etc. Work in well-cleaned and
well-ventilated areas only. Keep combustible
materials out of the work area. Never use
oxygen, carbon dioxide or other bottled
gases to power pneumatic tools.
• Do not point the tool at any person. Keep
children and other persons out of the work
area when operating the tool.
• Do not let the tool rotate in no-load ope-
ration.
• Disconnect air hose when changing grin-
ding wheels or accessories. Before chan-
ging grinding wheels or accessories, always
disconnect the tool from the air supply.
• Pneumatic tools must not get in contact
with sources of electricity.
• Pay attention to the working pressure,
max. air pressure see table on page 9.
Exceeding the approved maximum pressure
of tools and accessories can cause explo-
sions and may result in severe injuries. The
maximum pressure of the compressed air
must be equal or inferior to the approved
pressure load being indicated for the die
grinders.
• Check tight fit of the air hose connec-
tions / do not use defective pressure
hoses. Uncontrollably moving pressure
hoses may cause severe injuries.
• Only disconnect pneumatic tools in an
unpressurized state. Uncontrollably moving
pressure hoses may cause severe injuries.
• Use clean and dry air only. Never use oxy-
gen, carbon dioxid or other bottled gases to
power pneumatic tools.
• Only use spare parts, attachments and
accessories that are recommended by
the manufacturer.
• Never carry the tool by the pressure hose.
• Do not carry the plugged-in tool with a fin-
ger on the operation trigger.
• Avoid unintentional starting.
• Handles should be clean, dry and free of
oil and grease.
Do not leave plugged-in pneumatic tools unattended.
Always wear personal protective clothing and safety equipment.
For Your Safety
• Always keep the work area clean, well
• Do not use the tool under the influence of
• Any repairs must be carried out by autho-
• The labelling of the tool must always be
• Never use quick-release couplings that
Technical data are subject to change without notice
ventilated and well lit.
alcohol or drugs.
rized persons only.
clearly legible. The user is responsible
that the label showing speed, serial no.
and article no. is not damaged and is
always clearly readable.
are directly connected to the tool. An air
hose of 20 cm length minimum must
separate the quick-release coupling from
the tool.
USA GB
11