Maintenance; Maintenance Schedule - Husqvarna Zenoah GZ360 Manuel D'utilisation

7. Make sure that the blue grommet aligns with the
snow mark.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.

Maintenance schedule

Daily maintenance
Clean the external parts of the prod-
uct and make sure that there is no oil
on the handles.
Do a check of the throttle trigger and
throttle trigger lockout. Refer to
a check of the throttle trigger and
throttle trigger lockout on page 23 .
Make sure that there is no damage
on the vibration damping units.
Clean and do a check of the chain
To do a check of the
brake. Refer to
front hand guard and the chain brake
activation on page 22To do a check
of the chain brake on page 23 .
Do a check of the chain catcher. Re-
To do a check of the chain
fer to
catcher on page 23 .
Turn the guide bar, do a check of the
lubrication hole and clean the groove
in the guide bar. Refer to
check of the guide bar on page 31 .
321 - 006 - 08.11.2018

Maintenance

Weekly maintenance
Clean the cooling system. Refer to
Cooling system on page 32 .
Do a check of the starter, starter rope
To do
and return spring.
Lubricate the needle bearing. Refer
to To lubricate the needle bearing on
page 31 .
Remove burrs from the edges of the
guide bar. Refer to
the guide bar on page 31 .
Clean or replace the spark arrestor
mesh on the muffler.
Clean the carburetor area.
To do a
8. If the temperature is -5˚ or colder, assemble the
winter cover on the starter.
CAUTION: If you assemble a winter kit or
winter cover, remove them before you use
the product in temperature above 0˚. This
prevents damage on the engine.
Monthly maintenance
Do a check of the brake band. Refer
To do a check of the brake band
to
on page 22 .
Do a check of the clutch centre,
clutch drum and clutch spring.
Clean the spark plug. Refer to
a check of the spark plug on page
27 .
Clean the external parts of the carbu-
To do a check of
rettor.
Do a check of the fuel filter and the
fuel hose. Replace if necessary.
Do a check of all cables and connec-
tions.
To do
21