Cooling System - Husqvarna Zenoah GZ360 Manuel D'utilisation

5. Examine if the guide bar tip is rough or very worn.
6. Make sure that the bar tip sprocket turns freely and
that the lubricating hole in the bar tip sprocket is not
blocked. Clean and lubricate if it is necessary.
7. Turn the guide bar daily to extend its life cycle.
To do maintenance on the fuel tank
and the chain oil tank
• Drain and clean the fuel tank and the chain oil tank
regularly.
• Replace the fuel filter yearly or more frequently if
necessary.
CAUTION: Contamination in the tanks
causes malfunction.
To adjust the oil flow
WARNING: Stop the engine before you
make adjustments to the oil pump.
1. Turn the adjustment screw for the oil pump. Use a
screwdriver or combination wrench.
a) Turn the adjustment screw clockwise to decrease
the chain oil flow.
32
b) Turn the adjustment screw counterclockwise to
increase the chain oil flow.

Cooling system

The cooling system keeps the engine temperature
down. The cooling system includes the air intake on the
starter (1) and the air guide plate (2), the pawls on the
flywheel (3), the cooling fins on the cylinder (4) and the
cylinder cover (5).
4
1
1. Clean the cooling system with a brush weekly or
more frequently if it is necessary.
2. Make sure that the cooling system is not dirty or
blocked.
CAUTION: A dirty or blocked cooling system
can make the product too hot, which can
cause damage to the product.
Air cleaning system
™
AirInjection is a centrifugal air cleaning system that
removes dust and dirt before the particles are caught by
3
2
321 - 006 - 08.11.2018
5