Using The Sleep Timer - Sony STR-DE435 Mode D'emploi

Other Operations Receiver Operations
Recording on a video tape
You can record from a TV or a LD player using the
receiver. You can also add audio from a variety of
audio sources when editing a video tape. See your
VCR's instruction manual if you need help.
1
Press TV/LD to select the programme source.
2
Set the component to be ready for playing.
For example, turn on the TV and TV tuner.
3
Insert a blank video tape into the VCR for
recording.
4
Start recording on the VCR.
You can replace audio while editing a video tape
At the point you want to start adding different sound,
press another function button (for example, CD) and
start playback. The sound from the selected component
will be recorded over the original audio.
To resume recording the original sound, press the TV/
LD function button.
Note
You cannot record the audio and video signal during
5.1 CH/DVD mode.
26 GB

Using the Sleep Timer

Using the controls on the remote, you can set the
amplifier to turn off automatically at a time you
specify.
SLEEP
Press SLEEP on the remote while the power is on.
Each time you press SLEEP, the time changes as shown
below.
n 2:00:00 n 1:30:00 n 1:00:00 n 0:30:00 n OFF
The display dims after you specify the time.
You can freely specify the time
Press SLEEP on the remote first, then specify the time
you want using the cursor buttons (> or .).
The sleep time changes in 1 minute intervals. You can
specify up to 5 hours.
You can check the time remaining before the
amplifier turns off
Press SLEEP on the remote. The remaining time appears
in the display.
>/.