Removing Attachments; Switching On/Off / Selecting A Heat Level; Using The Attachments; Large Round Brush - SilverCrest SWC 1000 D1 Mode D'emploi

Removing attachments

■ First switch the appliance off and allow it to coosl down.
Press the release button "push" 7 and turn the attachment anti-clockwise
■
■ The attachment can now be removed by pulling it out of the attachment inser-
tion slot 1.
Switching on/off / Selecting a heat level
■ When you have inserted the required attachment and connected the plug
with the mains power socket, you can now switch the appliance on with the
level switch 3 and select the output level:
– "0"
– "1"
– "2"
You switch the appliance off by sliding the level switch 3 to the position "0"
■
(= appliance off).
To fix the styling, you can use the slide switch Cool Shot 2. The styling will
■
be fixed by the cool air stream:
During operation, slide the slide switch Cool Shot 2 upwards.
–
The air flow will be cooler.
– When you want to deactivate the cool air stream, slide the slide switch
Cool Shot 2 downwards.

Using the attachments

Large round brush q
This attachment gives the hair more volume or large curls.
Wind a slightly damp strand of hair around the large round brush q.
■
■ Switch the appliance on at level 1 or 2.
When the strand is dry, slide the slide switch Cool Shot 2 upwards.
■
Wait until the strand has cooled.
Unwind the large round brush q from the strand.
■
■ Proceed with the other strands in the same way.
SWC 1000 D1
The appliance is switched off
for a reduced air-flow strength with heat
for a high air-flow strength with heat
.
GB │ IE │ 9 ■