Power; Operation; Adjusting The Volume; Fm Radio Mode - THOMSON MIC200BT Mode D'emploi

Power

CAUTION
• Risk of product damager! Make sure that the power voltage
corresponds to the voltage printed on the back label.
• Risk of electric shock! When you unplug the AC power cord
always pull the plug from the socket. Never pull the cord.
• Before connecting the AC power cord, ensure you have completed
all other connections.
Place the unit in the desired position and unravel the mains cable. Insert the cable into the supply
socket and switch on if applicable.
Auto standby
When playing media from a connected device, the Tower automatically switches to standby if:
• No button is pressed for 10 minutes,
• No audio from a connected device for 10 minutes.
Battery power
• Be sure that the batteries are inserted correctly to avoid damage to the appliance. Always remove
the batteries when appliance will not be used for a long period of time, as this will cause leakage to
the batteries and subsequently damage to your set.
• Use batteries of the same type. Never use different types of batteries together.
• Do not throw the battery into the fire, or exposed to sunshine or the like.
• If the liquid contained in the batteries comes in contact with eyes or skin, wash the area immediately
and carefully with clear water and consult a doctor.
Unit power supply (mains 230V/50Hz)
Connect the power cable plug to the (230V) wall outlet.
Warning:
• Before using the unit, check that the local mains supply is compatible with the unit 230V (50Hz).
• Do not plug or unplug the power cable when your hands wet.
• When planning not to use this unit for long periods of time (i.e., Vacation etc.) disconnect the plug
from the wall outlet.
• When disconnecting the power cord from the wall outlet, grasp the plug; do not pull the cord
in order to avoid shock risks caused by the damaged cable.

Operation

Press the POWER/MODE button to turn on the unit.
Press and hold the POWER/MODE button for 2 seconds to turn off the unit.

Adjusting the volume

Turn the volume knob clockwise to increase the volume.
Turn the volume knob anti-clockwise to decrease the volume.
Check the display to confirm the volume setting.
Mute function
Press the MUTE button on the remote control; the volume is muted and the volume level number will
begin to flash on the LCD display. Press this button again to cancel the mute function.

FM Radio Mode

If you are not already in FM mode, press and release the POWER/MODE button repeatedly to go to
FM mode (check the display).
If you were listening to an FM station when you switched the radio off, then this station will be
- EN 5 -