HP COLOR LASERJET ENTERPRISE CP4020 Guide D'installation page 5

i. ON
j. ADDRESS
3. Press the up arrow
OK button.
Repeat this process for each character in the address.
NOTE:
4. Press the up arrow
5. Press the
Manually configure IPv4 TCP/IP parameters from the control panel
1. Press the
2. Open each of the following menus. Press the down arrow
OK button to select it.
a. CONFIGURE DEVICE
b. I/O
c. EMBEDDED JETDIRECT MENU
d. TCP/IP
e. IPV4 SETTINGS
f. CONFIG METHOD
g. MANUAL
h. MANUAL SETTINGS
i. <IP ADDRESS>, SUBNET MASK, or DEFAULT GATEWAY
3. Press the up arrow
of the IP address, subnet mask, or default gateway.
4. Press the
the previous set of numbers.
5. Repeat steps 3 and 4 until the IP address, subnet mask, or default gateway is complete, and
then press the
6. Press the
ENWW
or the down arrow
You must press the OK
or the down arrow
Home button to return to the Ready state.
Home button .
or the down arrow
OK button to move to the next set of numbers, or press the back arrow
OK button to save the setting.
Home button to return to the Ready state.
to select the first character of the address. Press the
button after entering each character.
to select the stop character
to increase or decrease the number for the first byte
. Press the
to highlight it and then press the
Network installation
EN
OK button.
to move to
3 5