vitapur VWD9506W Guide D'utilisation page 9

WATER LEAKAGE DETECTION SYSTEM:
This water dispenser is equipped with a low voltage water leakage detection
system located inside the base of the filter compartment and is covered by a
removable drip tray (See Fig. 16). In the event any water makes contact with
the leakage detection system, an audible alarm will sound (beep) continuously
until the water is removed. Upon activation of the leakage detection system, the
water inlet solenoid valve (located internally) is automatically (closed) deactivated
suspending incoming water activity until the alarm is silenced. To silence the
alarm, any/all accumulated water surrounding the sensors, must be removed
using a sponge and/or paper towels. The water inlet solenoid valve (opens)
reactivates automatically once the alarm is silenced.
FILTER REPLACEMENT:
For optimum water efficiency and performance, we recommend replacing the filter every 6 months. Replacement filters
can be ordered by contacting our CUSTOMER SERVICE DEPARTMENT (TOLL FREE) AT 1-877-447-4768 OR YOU CAN
ORDER ON-LINE AT; www.ghpgroupinc.com. Replacement Filter part number is VSRF-9.
CAUTION: Always turn off the water supply, using manual shut-off valve located at the rear of the dispenser, before
replacing filter. This will depressurize the water line and minimize water overspray when the filter is released. Remove
and empty drip tray under filter of any accumulated water. If the audible alarm sounds, refer to "WATER LEAKAGE
DETECTION SYSTEM" instructions.
INITIAL PRODUCT CLEANING:
Like most appliances, your water dispenser requires periodic maintenance for
maximum efficiency and performance and must be cleaned on a regular basis,
(coincide with filter replacement i.e. every 6 months) in order to maintain a
hygienic environment and prevent potential formation (growth) of bacteria. A
cleaning kit is available through our Customer Service Department at
1-877-447-4768 or can be ordered on line at www.ghpgroupinc.com, or you can
pre-mix a solution of 15ml (1 tbsp) bleach with 4.5L (1.2 gal) of hot water.
1. Always disconnect (unplug) the power cord before attempting any
cleaning, maintenance and filter replacement.
2. Always turn off the water supply, using manual shut-off valve at the rear
of the dispenser, before attempting any cleaning, maintenance and filter replacement.
Fig. 17 Fig. 17A
9
Fig. 16
Cleaning Kit
Available online at
www.ghpgroupinc.com
Fig. 17B