Important Safeguards - vitapur VWD9506W Guide D'utilisation

Thank you for purchasing a Vitapur® Water Dispenser. Please read the enclosed
operating instructions carefully and retain this booklet for future reference. We have carefully
engineered your Vitapur® Water Dispenser to give you years of enjoyment and trouble free operation.
IMPORTANT NOTE: Your Vitapur® water dispenser is designed with a special "safety" feature (float switch
mechanism) that controls activation/operation of the "Kettle Feature" hot water tank heating system. If no water is
present and/or low water levels are detected inside the internal reservoir system, activation/operation of the hot water
heating system is not possible. Likewise, if the hot water heating is operational and water is being drawn simultaneously
causing water levels to drop below safe levels, hot water tank operation is automatically terminated until normal water
levels are restored, at which time you must "manually" re-activate the hot water heating system by pressing the kettle
feature (red) button. NOTE: Operation of the cold water system is not affected by this safety feature.
WARNING: This Product can expose you to chemicals including Diisononyl phthalate (DINP) which is known to
the State of California to cause cancer and Di-isodecyl phthalates (DIDP) which is known to the State of California
to cause birth defects or other reproductive harm. For more information go to www.p65Warnings.ca.gov

IMPORTANT SAFEGUARDS

• This water dispenser is designed for "indoor" use only. DO NOT USE OUTDOORS.
• Never turn the dispenser upside down or tilt more than 45 degrees. During transportation, if the dispenser was
transported in a "prone" (sideways) position, the unit must be left to stand upright for 12 hours before connecting to
power source and initiating operation.
• This water dispenser is equipped with a grounded power cord and plug for your safety.
• Keep your water dispenser in a dry place away from any heat source and direct sunlight.
• Never put anything flammable close to the dispenser.
• Leave a minimum of 2" (5cm) around the back and sides of the dispenser for proper ventilation.
• Always install your water dispenser on a level (solid) floor.
• Wait 3 minutes before restarting machine after shutting it down.
• Always unplug (disconnect) the water dispenser power cord before servicing, cleaning and filter replacement.
• Service must be performed by qualified/authorized service personnel only. Service information is available through
our Customer Service Department at 1-877-447-4768.
• Regular cleaning of your water dispenser is required for your warranty.
• Please follow the cleaning and maintenance instructions outlined in this manual. Cleaning should be done every
4 ~ 6 months.
• It is your responsibility to ensure that all water line connections are properly connected and sealed and
there are no system water leaks before operating the unit.
• Although this unit incorporates provision of a (hot water) "child resistant safety switch", never allow children to
dispense hot water without proper and direct supervision.
DANGER: The hot water in this dispenser is heated to approximately 90°C (194°F). Temperatures above 52°C
(125°F) can cause severe burns from scalding.
• Only use original (OEM) Vitapur (VSRF-9) replacement filters with this unit.
2