Installing & Cleaning Reusable Cloth Filter; Installing & Cleaning Foam Sleeve Filter - Build Worker BVC1100-18SS Mode D'emploi

& CLEANING REUSABLE CLOTH FILTER
Installing Reusable Cloth Filter
1. Verify that the power cord is disconnected from the outlet
2. Remove power head and place in upside down position.
3. Slide reusable cloth filter down over the filter cage making sure the whole cage is covered.
(fig.1 & 2)
4. Replace the power head on to the container.
Removing and Cleaning Reusable Cloth Filter
1. With the removed power head in the upside down position.
2. Carefully remove the reusable cloth filter from the filter cage. (fig. 3) Clean the filter by gently
tapping or brushing dirt off. Cleaning should not be done indoors in living areas.
3. Use a mild soap and water solution to wash reusable cloth filter and rinse with clean water.
(fig. 4)
4. Allow the wet filter to air dry for 24 hours before installing onto the filter cage.
INSTALLING & CLEANING FOAM FILTER
Installing Foam Sleeve Filter
1. Verify that the power cord is disconnected from the outlet
2. Remove power head and place in upside down position. Follow instructions to remove cloth
filter.
3. Carefully slide foam sleeve filter down over the filter cage making sure the whole cage is
covered. (fig.1 & 2)
4. Replace the power head on to the container.
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam sleeve filter.
(fig. 3)
2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean water.
(fig 4.)
3. Allow filter to air dry before installing and using again.
INSTALLING
41