Liquid Vacuum Operation; Important - Build Worker BVC1100-18SS Mode D'emploi

LIQUID VACUUM OPERATION

LIQUID VACUUMING
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED
'SAFETY INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS WITH FLAMMABLE
GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS
INCLUDE BUT ARE NOT LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-
BASE PAINTS, GASOLINE, ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS
INCLUDE BUT ARE NOT LIMITED TO; COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO
REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM
TOXIC MATERIALS.
WARNING
: DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Remove reusable cloth filter, then carefully install the foam sleeve filter over the filter cage and
place the power head back on the container. (fig.2) See filter installing instructions on page
10.
DO NOT USE THE REUSABLE CLOTH FILTER FOR LIQUID VACUUMING.
OPERATING INSTRUCTIONS – WET VACUUMING
3. Fit the desired nozzle to the vacuum hose. (fig.3)
4. Verify that the switch is in the 'O' OFF position before plugging the power cord into the outlet.
(fig.4)
5. Turn the motor on by pressing the switch to the 'I' ON position. (fig.5)
6. After use, empty the container, clean and dry the inside and outside before storage. (fig.6)

IMPORTANT!

When vacuuming large quantities of liquids, do not immerse the nozzle
completely in the liquid; leave a gap at the tip of the nozzle opening to allow air inflow. The
machine is fitted with a float valve that stops the suction action when the container reaches its
maximum capacity. You will notice an increase in motor speed. When this happens, turn off the
machine, disconnect from power supply, and drain the liquid into a suitable receptacle or drain.
To continue vacuuming, refit the container with the drain cap. After wet vacuuming, turn the
machine off and remove plug from power supply. Empty the container, clean and dry the inside
and outside before storage.
REMEMBER!
The foam filter must be removed after wet vacuuming, and a reusable cloth filter
must be installed before dry vacuuming again.
38