General Assembly Instructions - Build Worker BVC1100-18SS Mode D'emploi

GENERAL ASSEMBLY INSTRUCTIONS

WARNING
: DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG
IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Undo the latches. (fig.2)
3. Lift the power head off the container. (fig.3)
4. Remove the contents from inside the container, make sure you have all contents as listed on
page 5. (fig.4)
5. Insert the casters into the socket on to bottom of the container and apply pressure until castors
snap into place. (fig.5)
6. For dry vacuum cleaning, install the supplied dust filter. (fig. 6) See page 10 for filter
installation.
7. For wet vacuum cleaning, install the supplied foam filter. (fig.7) See page 10 for filter
installation.
8. Place the power head back on the container, aligning the top section with the latches, and
snap into place. (fig.8)
9. Insert the locking end of the hose into the port of the container and turn to lock in to place.
(fig.9)
10. Choose the desired accessories and insert onto the end of the hose. (fig. 10)
A Philips head screw driver is required
36